Zhejiang Yadina new material technology Co., LTD

Stock code (833301)


Product introduction


网站首页 > Products > Melamine foam > Features

Cleaning up the stain

Yadina melamine foam with very surprising ability to wipe clean, mainly due to the raw material of melamine resin during processing, almost as hard as glass, can make the foam like very fine sandpaper, removing dirt particles from the surface friction; At the same time the denali melamine foam height the opening rate of the internal air with crosslinking network formation, the network is composed of very fine and flexible plastic fiber, the structure of air produced by huge, easy to contact surface can bind dirt particles, thus giving melamine foam magical decontamination ability. The decontamination effect can be applied in many surfaces, such as ceramic tile, ceramic, door, leather chair, etc., and there's no need to use cleaner, only need a little water to wet foam cleaning brush, even the most stubborn stains can't resist melamine resin as hard as glass microstructure, only is easy to wear and the surface of the paint should not be wiped clean with clean.

Yadina miamine-foam sponge is a new type of environmental protection sponge with many excellent properties, such as sound-absorbing, flame retardant, heat insulation, humidity and heat resistance, good cleaning performance, low density, light weight, health safety and good secondary processing. It is a flexible open foam made from melamine resin. It is a thermosetting resin plastic in the amino plastics family. Its characteristic is reflected in its high porosity fine three - dimensional mesh structure.

The Yadina melamine foam as a chemical new materials, the products are widely used in civil, traffic, military, automobile manufacturing, automobile industry, plant construction, building insulation, acoustic laboratory, studio thermal engineering, equipment, air conditioning system, field of aerospace navigation, electronic products, daily cleaning, high-speed rail, light rail, subway, rail transportation, equipment room, air duct, doors, walls, roof, seat of the compartment, side wall thermal insulation, floor etc. Need to drainage and surrounding the engine.

Yadina lamine foam has outstanding sound and heat insulation effect, and is lighter than the traditional sound and heat insulation cotton, reducing the weight of the vehicle, improving the safety of turning, and reducing energy consumption. Adinamine foam can provide an efficient solution for industrial noise reduction. After the heterosexual cutting can be used for automobile engine thermal insulation cotton, hood muffler cotton; Construction: indoor flame retardant soft bag, KTV theater flame retardant silencing cotton, theater, sports ground, high-grade residence; Industry: gas pipeline, wind pipe, hot water heater, air conditioner, plant noise reduction and insulation and other fields have very important application value, especially suitable for flame retardant, high temperature, noise reduction under the conditions of demand, is a new environmental protection material with great development prospects in the 21st century.

The Yadina melamine foam device absorbs the advantage technology, through independent development, innovative design, USES the original technological process, advanced processing equipment and perfect control system, the production of modified melamine resin as the main raw material to produce new environmental protection material, the denali melamine foam device of a complete set of mature, reliable, stable performance.

Yadina foam is light, with a density of only (8-11kg /m). It can be cut in different thickness and in various shapes according to requirements. It can be coated on the surface according to requirements.

Yadina foam foam is a melamine sponge with high fire resistance and sound absorption.

Yadina foam has an ultra-light mass (8-11kg /m) that can be used to replace conventional fiberglass cotton to greatly reduce weight.

Yadina foam can pass European aviation, train, construction and other standards. Can be used in low temperature -200℃ high temperature up to 240℃ environment, can be attached to the film as required. Adhesive may be used to attach to the installation area, but the surface needs to be cleaned before bonding, which can be fixed by means of mechanical fixation. For civilian use.